1. Barrel arrel is cooled by oil circulation, temperature shock is very low and keep extruding profile to be uniform. High torque output of gearbox.
2. Screw & barrel is using ACM-2 to be base material, with heat-treatment and Nitrogenizing & precise grinding. This will make screw and barrel to be anti-acid and wear resisting.
3. Vacuum vent of extruder can eliminate the vapor and gases insideraw material.
4. Control system is using PID with SSR components.
5. Die material is using alloyed steel with anti-acid advantage .
6. Plastic Extrusion Machine.
1. Screw dia: 75 mm x 2.
2. L/D ratio: 22:1.
3. Screw material: all oyed steel acm-2(craini).
4. Barrel material: jis sacm-1.
5. Heating type: heater.
6. Cooling type: air-cooling / oil-cooling.
7. Heating zone: 8 zones.
8. Heater capacity: 15 kw.
9. Control panel: independent.
10. Gear material: scm-25.
11. Extruder type: single-screw.
12. Screw rotation direction: counter rotating.
13. Screw rpm: 60 rpm.
14. Circulation lubricant: 20#.
15. Gearbox type: oil circulation.
16. Resin feeding motor: 1 hp.
17. Lubrication motor: 1 hp.