*Optimal Wind Maximum Power Point Tracking
*Wind & Solar Charge Controller
*Can be paralleled (Max. 16 sets) at will; according to your demand.
*Battery charge management; state of charge infromation.
*Built-in Battery Energy Monitor tracks Power production and consumption to calculate the energy remaining in battery state of charge (SOC) is displayed in percent full; Amp-hours; Watt-hours; and 90days of energy-harvest history is stored in the wind charger.
*Continuous output Power Rating without de-rating at up to 50°C ambient temperature.
*Supports Flooded Lead Acid (FLA); GEL; and Absorbed Glass Mat (AGM) batteries; 2/3/4 Stage charging with adjustable set point.
*Input acceptance up to 220VAC or 240VDC normal (240VDC Max).
*Built-in temperature compensation function for safe and complete charging.
|Input Voltage Range (no damage)||0 ~ 220 VAC|
| Operating Input Voltage Range from PMG|
(Permanent Magnet Generator)
|20 ~ 220 VAC|
0 ~ 600 Hz
|Optimal Range: 20 ~ 180 VAC|
|System voltage ratings||12; 24; 36; 48 VDC|
|Current ratings-Battery Charge Control||100A|
|Max. Current in the Brake Resistor||100A |
|DC Input Voltage Range||16 ~ 240 VDC Operating|
|240 VDC Maximum|
|Automatic Brake Function||5 Level: |
200; 210; 220; 230; 240 VDC
Can be customized for the wind turbines
|Maximum Wind Turbine Capacity|
|Charging 48 VDC Batteries||6.0KW|
|Charging 36 VDC Batteries||4.5KW|
|Charging 24 VDC Batteries||3.0KW|
|Charging 12 VDC Batteries||1.5KW|
|Charge Regulation Modes||Bulk; Absorption; Float; Auto/ Manual Equalization|
|Battery Temperature Compensation||5.0 mV per °C ; per 2 volt cell|
|DC to DC Conversion Capability||12V Battery: 16~240VDC|
|24V Battery: 32~240VDC|
|36V Battery: 48~240VDC|
|48V Battery: 64~240VDC|
|Display Status||Built-in 2-line; 20-character LCD with backlight|
LCD status screen displays input voltage and
current; output voltage and current; charge-mode;
|Data Logging||Logs energy harvested for 90 days; LCD displays WH; KWH; AH|
|Energy Monitor||LCD shows SOC; AH; WH; and present charge or discharge current. A 50mV/ 500Amp shunt is required to use|
|Auxiliary Relays||Two independent relays with from A (SPST) contacts for control of external devices. Contact rating is 3 Amps; 50VDC|
|Operation Temperature||Full Power Output to +50 °C ambient|
|Standby Power||< 2 Watts|
|Relative Humidity||0 ~ 100% condensing|
|Dimensions (mm) [H x W x L]||401 x 258 x 183|
|Optional Diversion Load|
|Specifications subject to change without notice|