1. Can be connected on-line with main machine or working independently (SL-300C working independently only).
2. Equip on length and sheet amount sensors. Machine will stop automatically when setting amount is achieved.
3. Easy setting slitting knives no need to release then tighten by screws as other machine to avoid knives angle not proper cause material wastage & adjusting trouble or dangerous & damage due to operator forget to lock the screws. The knives position can be adjusted while slitting thanks to the smart device.
4. Air blower is accompanied with machine to blow away the web waste trim edge. Product shaft can be used for different diameter.
5. Adjustable Vacuum tension device to get clean trim tight roll. Unwind & rewind product shafts can rewind the printed roll for 2nd pass use.
6. Speed reducing program can be settled when the amount almost achieved to reduce the slitting speed in order to save material wastage and machine longer life.
1. Specification SL-340CR / SL-300CR / SL-300C.
2. Max. web width: 340 mm (SL-340CR) / 320 mm (SL-300CR / SL-300C).
3. Min. slitting width (mm) 10 mm, 7 knife sets for standard (special order to be requested).
4. Max. web rewind outer dia. ψ550 mm run around 1000 M ( special design to be requested ).
5. Rewind shaft dia. 75 mm.
6. Max. speed: connected on-line : As main machine or Working independently : 75 M / min (SL-300C working independently only).
7. Power: 1/2 HP, 220 V / 50 (60) Hz.
8. Machine weight: 163 KG (N.W.), 245 KG (G.W.).
9. Measurement: 1.5 CBM.