Xembourg Enterprise Co., Ltd.

Professional Automotive Repair Equipment Manufacturer & Supplier

Hot Products

Combination Electronic Stethoscope Kit
  • Model No:
    JTC-1449
  • Product Description:
    • To locate & indentify noise and enable road test diagnosis.
    • Super sensitive microphone pick up.
    • Defect & isolate noisy components.
Automotive Telescopic Transmission Jack
  • Model No:
    JTC-TJ1000
  • Product Description:
    •Fully adjustable universal saddle with adjustable corner brackets and safety chain.
    •Bracket and chain slings are adjustable to accommodate transmissions; clutches and differentials of varying sizes.
    •Wide base with four 3-1/2" dia. Swivel ca...
Hydraulic Press M/C
  • Model No:
    JTC-SP350A
  • Product Description:
    • Using for wide range of mechanical parts; such as bends deforms; combined for reformation or shaft bearing; gear; press in or extruded
    • It designed with double speed of high and low pressure.
Universal Pulley Remover
  • Model No:
    JTC-4142
  • Product Description:
    * Special designed to remove most of belt pulleys.
    * With setting screws M6, M8 3pcs of each.
Sub-Frame Bush Installer/ Remover
  • Model No:
    JTC-4138
  • Product Description:
    * For replacement of the front and rear metallic rear sub-frame mounting bush.
    * Replacement of the mounting bushes without removing the complrte rear axle assembly.
Exhaust Pipe Separator
  • Model No:
    JTC-4057
  • Product Description:
    Designed especially for providing pull out the exhaust pipe easily.
Coil Spring Compressor
  • Model No:
    JTC-F270
  • Product Description:
    • Drop forged CR-V steel jaws & leaded screws (270mm) both heat treated ensure you obtain professional job performance.
    • The tool is designed for use in limited space under wheel arch.
DCA/ACA CLAMP METER
  • Model No:
    JTC-1229
  • Product Description:
    • Use two hell-effect sensors
    • For use with any multimeter with 200mv or/and 2v ranges for direct readout.
    Input impedance of at least 1mΩ.
    • An LED lights up when the clamp is under power
    • Zero adjuslment knob to compensate the hysteresis ef...