* Machine with Mitsubishi PLC or LNC CNC is designed for drilling turbine shaft.
* Servo motor and ball screw are used for the feed mechanism to insure smooth and convenience for feed rate adjust.
* Slide ways are heat-treatment t o hardness HRC52 and ground way are based on mechanic cast iron. The Opposite ways and gibes are all * Turcite-B plated with hand scraped bearing surface.
* The enhanced ribs in the major construction provides the excellent rigidity.
* Automatic lubrication pump is provided as standard accessory to ensure all bearing surface and screws are well lubricated.
* Four filtration systems (paper filter, magnetic separator chip auger and tank filter) are standard accessories to keep the oil clean.
* The excellent design of oil flow cycle provides plentiful oil to lower the temperature of drilling and drill smoothly.
Ø3- Ø 9mm
Max. drilling length
Max. travel of slide (Z axis)
Ø40× P10 (HIWIN)
Feed motor (AC servo motor)
Cast iron F25C (Heat treatment HRC 52)
Component holding system
Mode of loading and unloading
Component clamping way
6" manual 3-jaw chuck × 2Nos
Clamping range of component size
Mode of operation
Tool rotating & feeding,
Motor for rotating component
Total tank capacity
Delivery LPM (Max.)
High pressure pump
Variable flow pump
Magnetic separator, tank filter
Mode of lubrication
Auto through PLC
Machine total power