Yueqing Lide Electric Co.,Ltd

Ms. Vivian Chi (China)

Trade Leads

RS/RM Triac/2SCR Analog SSR solid state relay

  • Posted Date : 2019-10-21
  • Expiry Date: 2020-04-21
  • Category :
    • Consumer Electronics > Electrical Appliances

Content :

RS TRICA bi-directional thyristor zero switching solid state relay,two input ranges: D:3-32VDC and A:170V-250VAC,output:230VAC,400VAC,480VAC
The zero switching rellay with trica or alternisstor output is an inexpensive solution for resistive loads.The zero switching relay swithing ON the sinusoidal curve crosses zero and switches OFF when the current crosses zero.The LED indicates the status of the control input.The clip-on cover is securing touch protection up to IP20.Output terminals can take cables up to 16mm^2.

RM1A 2SCR zero switching single phase solid state relay,2 input ranges: 3-32VDC and 20-280VAC/22-48VDC,built-in varistor 230,400,480
The industrial,1-phase relay with antiparallel thyristor output is the most widely used SSR due to its multiple application possibilities.The relay can be used for resistive,inductive and capacitive loads.The zero switching relay switches ON when the sinusoidal curve crosses zero and switches OFF when the current crosses zero.The instant-on relay with DC control input can be used for phase control.The built-in varistor secures transient protection for the industrial application,and the LED indicates the status of the control input.The clip-on cover is securing touch protection to IP20.Protected output terminals can handle cables up to 16mm^2.

RM1E 2SCR analog swiching (phase-angle control) solid state relay voltage regulation,input:4-20mA,rated operation voltage:230VAC,400VAC,480VAC,rated operation current:25A,50A,100A
The analog switching relay works in accordance with the phase angle control principle,i.e. the output switching point in the AC sine wave depends on the control current.4mA corresponds to no switching and 20mA corresponds to full sine wave(near linear power response).The relay switches off every time the output current crosses zero,and switches ON in accordance with the applied control current.